tag:blogger.com,1999:blog-1241233588755403188.post6800779541128115076..comments2024-03-22T14:13:54.465-04:00Comments on Techs Palace: How to setup network bridgeRoshan Karkihttp://www.blogger.com/profile/18409357804471363219noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-1241233588755403188.post-22928234798571660552010-08-21T02:41:35.203-04:002010-08-21T02:41:35.203-04:00I ran into a situation with Ubuntu Server 10.04.1 ...I ran into a situation with Ubuntu Server 10.04.1 LTS where after installing the prereqs for OpenVPN and trying to configure it that br0 would *not* go up no matter how many guides I followed. Finally I used apt to junk bridge-utils and reinstalled it. First try was a success. Don't know what changed in the repos but if anyone else has this problem following actual Ubuntu help guides this may help cure it.Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-1241233588755403188.post-55045563802911686492009-04-13T01:47:00.000-04:002009-04-13T01:47:00.000-04:00right post at right time thaks.right post at right time thaks.Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-1241233588755403188.post-87684314321886006182008-10-18T15:39:00.000-04:002008-10-18T15:39:00.000-04:00thanks!is what i'm looking forthanks!<BR/>is what i'm looking forAnonymousnoreply@blogger.comtag:blogger.com,1999:blog-1241233588755403188.post-84172003809365472142008-08-26T08:44:00.000-04:002008-08-26T08:44:00.000-04:00how about firewalling that bridge?how about firewalling that bridge?Anonymousnoreply@blogger.com